Nauja Kenwood TS-590S firmware

 

Prieš keletą dienų pasirodė nauja Lietuvoje populiaraus transiverio firmware versija. Pakeitimų joje nedaug ir jie mano akimis žiūrint nesvarbūs, bet kas norite...
Įdedu taip pat visų buvusių firmware atnaujinimų po v.2. pakeitimų sąrašą:

Updated item : (Version 2.03 2.04) [January 30, 2019]

The following feature is updated. 1. Enables to work as a "Sub-receiver" on "Split Transfer A" operation with using a TS-890S or a TS-590SG (firmware Ver.1.05 or later) as a "TX/RX End". Set both of the Menu No.58 and 59 to "ON" to turn the TS-590S Split Transfer function on in VFO operation. The TS-590S does not work as a "TX/RX End". Please use a TS-890S or a TS-590SG (firmware Ver.1.05 or later) as a "TX/RX End". For details of the "Split Transfer A" operations, please refer to the TS-890S instruction manuals or the revised TS-590SG instruction manuals.

Updated item : (Version 2.02 2.03) [November 17, 2016]

The following symptom is revised. 1. The internal antenna tuner may not work correctly under certain conditions.

Updated item : (Version 2.01 2.02) [December 9, 2015]

The following symptom is revised. 1. After changing the operating mode, the Split-frequency function might not work correctly.

Updated item : (Version 2.00 2.01) [July 28, 2015]

The following features are updated. 1. Enables NB1 and NB2 to be simultaneously set to ON. When the Noise Blanker is set to OFF, pressing and holding the [NB(LEV)] key enables NB1 and NB2 to be set to ON at the same time. Then, pressing the [NB(LEV)] key again enables NB1 and NB2 to be set to OFF. When NB1 and NB2 is set to ON at the same time, the Noise Blanker level cannot be adjusted. Adjust the Noise Blanker level once the Noise Blanker is set to OFF and NB1 or NB2 is set to ON. (Please also update both of the Radio Control Program ARCP-590 and the Radio Host Program ARHP-590 for functional compatibility.)

Updated item : (Version 2.03 2.04) [January 30, 2019]

The following feature is updated. 1. Enables to work as a "Sub-receiver" on "Split Transfer A" operation with using a TS-890S or a TS-590SG (firmware Ver.1.05 or later) as a "TX/RX End". Set both of the Menu No.58 and 59 to "ON" to turn the TS-590S Split Transfer function on in VFO operation. The TS-590S does not work as a "TX/RX End". Please use a TS-890S or a TS-590SG (firmware Ver.1.05 or later) as a "TX/RX End". For details of the "Split Transfer A" operations, please refer to the TS-890S instruction manuals or the revised TS-590SG instruction manuals.

Atnaujinimą galima rasti čia: https://www.kenwood.com/i/products/info/amateur/ts_590/ts590_update_e.html
TS-590SG paskutinis firmware atnaujinimas yra 1.06 ir jo turinys aprašytas https://www.kenwood.com/i/products/info/amateur/ts_590g/ts590g_update_e.html